![]() ![]() However, although the Web GUI allowed me to configure it in Access Point mode, the result was the same as before: After the page refresh the access point settings were no longer displayed. So I destroyed and created it in HOSTAP mode using the above commmands (without assigning an address or SSID), then used the opnsense shell to assign it to OPT2. Scanvalid 60 protmode CTS ampdulimit 64k ampdudensity 8 shortgi -ldpcĪfter several failed configuration attempts I hoped that the problem was that the ath0_wlan0 interface is created in infrastructure mode on boot. Media: IEEE 802.11 Wireless Ethernet autoselect mode 11ng Scanvalid 60 protmode CTS wme burst dtimperiod 1 -dfs Regdomain FCC country US ecm authmode OPEN privacy OFF txpower 30
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |